HOW CDR WORKS
The CDR utilizes four expertly engineered hydrocylcones that separate the hard sharp particles that typically stay suspended in a machine's coolant. The CDR's 3HP pump produces up to 80GPM flow rate in order to quickly capture harmful debris before it is recirculated through the machine.
The debris is separated out, and lands in the settling tank where it can easily be scraped out. The clean coolant returns to the machine tool tank, supplying your pumps with fresh coolant and protecting your machine from wear.
RETURN ON INVESTMENT
Averaging over a CDR’s life, it will typically pay for itself in 2 years.
- COST OF REPLACING SET OF WAYCOVERS: $5,000-$20,000
- COST OF REPLACING BALL SCREW/LINEAR GUIDES: Starting at $10,000+ per axis
- TOOL HOLDERS: $50-$100 each
- CHUCK: $4,000-$20,000
- MACHINES RUN IN SEVERE ENVIRONMENTS TYPICALLY NEED A MAJOR REBUILD IN 5-10 YEARS: $150,000
- COOLANT COST IN & OUT: $450-$1,050 per tank cleanout
- LABOR COST: $100-$640 per tank cleanout
Damage and maintenance costs increase over time, but wear may not be noticeable until it’s too late.
CUSTOMER TESTIMONIAL
- Up to 80 GPM flow rate
- Filtration down to 3 micron
- Cleanable Pre-filter
- No Disposable Filter Media
- Low maintenance
- 2 year parts warranty
- Inlet/Outlet Pressure Gauges
- Easy Install Kit
- PLC display
Note: All units are in inches.